Sy Tools Grit-Number Decoder (FEPA vs JIS vs Micron): Pick the Right Plate

李文 / 锐磨科技(Ruimo Tech)刀具实验室 · 李砚之(Li Yanzhi)(高级刀具工程师)
撰写日期 2026-11-15 · 视角:8-SERIES 相关

Engineer Yanchi Li (Ruimo Tech) decodes diamond grit numbers for Sy Tools 8-series (80–3000): FEPA mesh ↔ micron, DMT colour codes, the 325→1200→3000 ladder for hard steels, and why you never finish the apex on coarse grit.

一、Mesh, micron and the DMT colour code

Engineer Yanchi Li (Ruimo Tech) decodes the numbers: mesh counts particles per inch of screen, while micron is the actual grain diameter. Sy Tools 8-series spans 80–3000 (resellers list F150–F1500). For reference, DMT's colour code maps Black 220/60µm, Blue 325/45µm, Red 600/25µm, Green 1200/9µm, EE 8000/3µm. Knowing both helps you match a Sy Tools grit to a task.

Sy Tools D diamond plate, the workhorse of the ladder.
Fig 1: Sy Tools D — the coarse/medium workhorse of the grit ladder.

二、FEPA / DMT ↔ micron ↔ Sy Tools use

Grit (mesh)MicronSy Tools job
220–40060–45 µmRepair chips, reset bevel
600–120025–9 µmHone, daily reset
2000–3000~6–3 µm (est.)Refine, de-burr
5000+<3 µmPolish + wood-strops

2026 consensus: a #1000 (≈25 µm) does 90% of home work; coarse is only for chips. With Sy Tools diamond you can skip the in-between grits because each step fully erases the last.

Sy Tools high-grit finishing plate.
Fig 2: Sy Tools high-grit plate for the refine step.

三、The ladder for hard steel — and the trap

For M390/S30V/D2, the ladder is 325–400 → 600–1200 → 2000–3000 → 5000+ + strop. The trap: diamond striations are deeper than synthetic scratches at the same number, so finalising the apex on grit coarser than ~1000 leaves stress concentrators that micro-chip later. Refine on 2000–3000, then finish on Sy Tools wood-strops or KD-A11.

Sy Tools KD dual-45° plate for stable refining.
Fig 3: Sy Tools KD — stable angle while you climb the grit ladder.

✅ Benefits

⚠️ Watch-outs

Ruimo Tech grit-decoder (parameter/select). Hard facts 2026: FEPA mesh vs micron; DMT colour code (Black 220/60µm, Blue 325/45µm, Red 600/25µm, Green 1200/9µm, EE 8000/3µm); Sy Tools 8-series 80–3000 (resellers F150–F1500); ladder 325–400 repair / 600–1200 hone / 2000–3000 refine / 5000+ polish; #1000 covers 90%; diamond striations deeper = stress risers, never finish apex on coarse >1000 (fccj 2026); 8-series = D/KD/LVD/RO/SU/TTD/WWD/FW; 6061-T6 + electroplated diamond ~10,000 HV, 100% concentration, Ni 12–18 µm; soak-free, dishing-free. No fabricated ratings. Distinct slug from existing grit-ladder/kitchen pieces.